|
In data communications, bandwidth-delay product refers to the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds).〔RFC 1072: Introduction〕〔(Understanding Bandwidth-Delay Product in Mobile Ad Hoc Networks )〕 The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged. A network with a large bandwidth-delay product is commonly known as a long fat network (shortened to LFN and often pronounced "elephan"). As defined in RFC 1072, a network is considered an LFN if its bandwidth-delay product is significantly larger than 105 bits (12500 bytes). Ultra-high speed LANs may fall into this category, where protocol tuning is critical for achieving peak throughput, on account of their extremely high bandwidth, even though their delay is not great. An important example of a system where the bandwidth-delay product is large is that of GEO satellite connections, where end-to-end delivery time is very high and link throughput may also be high. The high end-to-end delivery time makes life difficult for stop-and-wait protocols and applications that assume rapid end-to-end response. A high bandwidth-delay product is an important problem case in the design of protocols such as TCP in respect of performance tuning, because the protocol can only achieve optimum throughput if a sender sends a sufficiently large quantity of data before being required to stop and wait until a confirming message is received from the receiver, acknowledging successful receipt of that data. If the quantity of data sent is insufficient compared with the bandwidth-delay product, then the link is not being kept busy and the protocol is operating below peak efficiency for the link. Protocols that hope to succeed in this respect need carefully designed self-monitoring, self-tuning algorithms.〔(Enabling High Performance Data Transfers ), Pittsburgh Supercomputing Center〕 The TCP window scale option may be used to solve this problem caused by insufficient window size, which is limited to 65535 bytes without scaling. ==Examples== * Moderate speed satellite network: 512 kbit/s, 900 ms RTT :: B×D = 512×103 b/s × 900×10−3 s = 460,800 b., / 8 = 57,600 B (or / 1,000 = 57.6 kB, or / 1,024 = 56.25 kB) * Residential DSL: 2 Mbit/s, 50 ms RTT :: B×D = 2×106 b/s × 50×10−3 s = 100×103 b, or 100 kb, or 12.5 kB. * Mobile broadband (HSDPA): 6 Mbit/s, 100 ms RTT :: B×D = 6×106 b/s × 10−1 s = 6×105 b, or 600 kb, or 75 kB. * Residential ADSL2+: 20 Mbit/s (from DSLAM to residential modem), 50 ms RTT :: B×D = 20×106 b/s × 50×10−3 s = 106 b, or 1 Mb, or 125 kB. * High-speed terrestrial network: 1 Gbit/s, 1 ms RTT :: B×D = 109 b/s × 10−3 s = 106 b, or 1 Mb, or 125 kB. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Bandwidth-delay product」の詳細全文を読む スポンサード リンク
|